« previous next »
Pages: 1 [2]

Author Topic: 3DO FZ-10 problems  (Read 16009 times)

pceslayer

Re: 3DO FZ-10 problems
« Reply #15 on: March 05, 2013, 10:46:46 pm »
I have a fz1 with a bad laser. Got a pic of the gear? I'll pull it off and send it your way if its intact.

Nvm just reread your post... Let me know if you need it.
« Last Edit: March 05, 2013, 10:48:59 pm by pceslayer »
Logged

ffxik

Re: 3DO FZ-10 problems
« Reply #16 on: March 06, 2013, 02:58:24 am »
Not with out dismantling one of the two...   Never mind I found this one while scouring the web awhile back.  I almost forgot about it.
Should be the first post.

http://www.assemblergames.com/forums/showthread.php?29347-need-a-fz1-3do-cd-laser-drive-shaft-gear


Logged

samson7point1

Re: 3DO FZ-10 problems
« Reply #17 on: May 03, 2013, 02:33:27 pm »
Just fired up my my FZ-1 and long story short, I have the same problem with the worm wheel gear you mentioned.  You still planning on casting and making some replacements?  I, for one, would be extremely grateful.
Logged

ffxik

Re: 3DO FZ-10 problems
« Reply #18 on: May 17, 2013, 07:16:33 am »
I do.  It's going to take a while though.  The minimum expense I am looking at for the materials to do this is well over $100.  Thanks to some rather boneheaded decisions recently I lack the funds to accomplish this goal.  May take a couple of months at least.   :-\

I do plan to charge for them of course.  I was thinking around $2.50 a piece.
« Last Edit: May 17, 2013, 07:18:23 am by ffxik »
Logged

Pages: 1 [2]
« previous next »